Fujitsu ETERNUS DX60 S3 - Page 994

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
994
■ Modify FC Port Parameters (when the port mode is "CA")
■ Modify FC Port Parameters (when the port mode is "RA" or "CA/RA")
Screen Setting item Default value
Port Settings Connection FC-AL
Set Loop ID Manual
Loop ID
• When "Set Loop ID" is "Manual"
0x0
• When "Set Loop ID" is "Automatic"
Ascending
Transfer Rate Auto-negotiation
Frame Size 2048 (bytes)
Reset Scope I_T_L
Release Reservation if Chip is
Reset
Disable
Screen Setting item Default value
Port Settings Connection FC-AL
Set Loop ID Manual
Loop ID
• When "Set Loop ID" is "Manual"
0x0
• When "Set Loop ID" is "Automatic"
Ascending
Transfer Rate Auto-negotiation
Frame Size 2048 (bytes)
REC Line No. 0
REC Transfer Mode
Sync (synchronous transfer
mode)
Enable
Async Stack (asynchronous
stack mode)
Async Consistency
(asynchronous consistency
mode)
Async Through
(asynchronous through
mode)