Fujitsu ETERNUS DX8100 S3 - Page 118

Chapter 3 Component Status
3.6 Controller Enclosure Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
118
The following items are displayed in the Main area:
• Charge Rate
The battery charge level for CE is displayed.
When the battery charge level is 90% or more, "Full Charge" is displayed. When the battery charge level is
less than 90%, "xx%" is displayed.
This item is displayed for the ETERNUS DX8700 S3/DX8900 S3.
• Cache Mode
The current status and the factor of the cache are displayed.
This item is displayed for the ETERNUS DX8700 S3/DX8900 S3.
- Write Back Mode
- Write Through (Pinned Data)
- Write Through (Battery)
- Write Through (Maintenance)
- Write Through (1CM)
• Serial Number
The serial number of the CE is displayed.
• Other Information
Additional information for the CE is displayed.
• Location
The installation location of the thermal sensor is displayed.
- Intake Temp
- Exhaust Temp
• Status
The status of thermal sensor is displayed.
• Error Code
The error code for the thermal sensor is displayed.
• Sensor 1
The temperature of CM#0 is displayed in Celsius (C) and in Fahrenheit (F).
If the thermal information is not available due to problem such as a sensor failure, a "-" (hyphen) is
displayed.
• Sensor 2
The temperature of CM#1 is displayed in Celsius (C) and in Fahrenheit (F).
If the thermal information is not available due to problem such as a sensor failure, a "-" (hyphen) is
displayed.