Fujitsu ETERNUS DX8100 S3 - Page 126

Chapter 3 Component Status
3.6 Controller Enclosure Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
126
● For the ETERNUS DX8100 S3
The following items are displayed in the Main area:
- Storage system image
The rear view of the CE that is installed in the ETERNUS DX is displayed.
The CM status, the CA status, BUD status, and the CPSU status are displayed with icons.
By clicking the CM number, the [Controller Module] screen is displayed. Refer to "3.7 Controller Module
Detail" (page 127) for display items.
By clicking the CA number, the [Channel Adapter] screen is displayed. Refer to "3.8 Channel Adapter
Detail" (page 132) for display items.
By clicking the BUD number, the [Bootup and Utility Device Detail] screen is displayed. Refer to "3.20
Bootup and Utility Device Detail" (page 169) for details.
By clicking the CPSU number, the [Controller Enclosure Power Supply Unit] screen is displayed. Refer to
"3.10 PSU/CPSU (CE) Detail" (page 140)
for display items.
- Parts
The CM number, the CA number, the BUD number, and the CPSU number is displayed.
By clicking the CM number, the [Controller Module] screen is displayed. Refer to "3.7 Controller Module
Detail" (page 127) for display items.
By clicking the CA number, the [Channel Adapter] screen is displayed. Refer to "3.8 Channel Adapter
Detail" (page 132) for display items.
By clicking the BUD number, the [Bootup and Utility Device Detail] screen is displayed. Refer to "3.20
Bootup and Utility Device Detail" (page 169) for details.
By clicking the CPSU number, the [Controller Enclosure Power Supply Unit] screen is displayed. Refer to
"3.10 PSU/CPSU (CE) Detail" (page 140)
for display items.
- Status
The status of each component is displayed. Refer to "A.5 Component Status" (page 410)
for details.