Fujitsu ETERNUS DX8100 S3 - Page 186

Chapter 3 Component Status
3.24 Port Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
186
● FCoE port
The detailed FCoE port information is displayed.
The following items are displayed in the Main area:
■ CE#x CM#y CA#z Port#w Information (for the ETERNUS DX8700 S/DX8900 S3) or
CM#y CA#z Port#w Information (for the other models)
- Location
The location information (x: CE number, y: CM number, z: CA number, w: Port number) of the port is
displayed.
• For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
• For the other models
CM#y CA#z Port#w
- Port Mode
The port mode (fixed to "CA") is displayed.
- Status
The port status is displayed. Refer to "A.5 Component Status" (page 410)
for details.
- Status Code
The port status code is displayed.
- Error Code
The port error code is displayed.
- Type
The type of the port (fixed to "FCoE") is displayed.
- Connection
The connection type of the port is displayed.
• Fabric
A connection type that enables simultaneous communication among multiple nodes through a
Fibre Channel switch.
• FC-AL
A connection type that connects multiple nodes in a loop.
- Transfer Rate
The transfer speed of the port (fixed to "10 Gbit/s") is displayed.
If the status is " Unknown", a "-" (hyphen) is displayed.