Fujitsu ETERNUS DX8100 S3 - Page 185

Chapter 3 Component Status
3.24 Port Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
185
- Transfer Rate
The transfer speed of the port is displayed.
If the status is " Unknown", a "-" (hyphen) is displayed.
• Auto-negotiation
• 1.5Gbit/s
• 3Gbit/s
• 6Gbit/s
- Link Status
The link status for each Phy is displayed.
If the status is " Unknown", a "-" (hyphen) is displayed.
• Phy#0 - 3:x
"x" indicates one of the following statuses:
- Link Down
- 1.5Gbit/s Link Up
- 3Gbit/s Link Up
- 6Gbit/s Link Up
- SAS Address
The SAS address is displayed.
If the SAS address is not specified, a "-" (hyphen) is displayed.
- Affinity Mode
The affinity mode of the port is displayed.
• ON
• OFF
- Part Number
The part number of the port is displayed.
If the part number cannot be acquired, a "-" (hyphen) is displayed.
- Serial Number
The serial number of the port is displayed.
If the serial number cannot be acquired, a "-" (hyphen) is displayed.
- Hardware Revision
The hardware version of the port is displayed.
If the hardware version cannot be acquired, a "-" (hyphen) is displayed.