Fujitsu ETERNUS DX8100 S3 - Page 294

Chapter 5 Connectivity Status
5.8 NAS
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
294
• CIFS Permissions
The CIFS access permissions that are set for the shared folder is displayed.
A "-" (hyphen) is displayed when the protocol is "NFS".
The CIFS access permissions are displayed in the following format.
- User name or group name [Type, Authority]
• Type
This item shows whether the displayed name is for user or group (u: User, g: Group).
• Authority
This item shows the access permission (r: Read Only, rw: Read/Write) for the displayed name.
"Read/Write" indicates that reading from and writing to the shared folder is allowed.
"Read Only" indicates that the shared folder is read only.
• If "Everyone" is displayed as the group name, the specified authority is applied to all users and
groups. In this case, "Type" is omitted.
[Example]
- aaa000 [u, rw]
Type is "User", name is "aaa000", and authority is "Read/Write".
- group0 [g, r]
Type is "Group", name is "group0", and authority is "Read Only".
- Everyone [rw]
Type is "Everyone" and authority is "Read/Write".
• User and group are user information that is managed in the Active Directory authentication server.
• "Read/Write" is given priority over "Read Only".
- If "Read Only" is specified for UserA and "Read/Write" is specified for GroupA in which UserA is a
part of, "Read/Write" is set for all users in GroupA including UserA.
- If "Read/Write" is specified for UserA and "Read Only" is specified for GroupA in which UserA is a
part of, "Read/Write" is set for UserA and "Read Only" is set for other users in GroupA excluding
UserA.
- If "Everyone" is selected for the CIFS access permission type, the authority is set with the same
conditions as when "Read/Write" or "Read Only" is set to all groups in the ETERNUS DX.