Fujitsu ETERNUS DX8100 S3 - Page 395

Chapter 8 Advanced Copy Status
8.8 Advanced Copy (Property)
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
395
• Destination Volume Name
The following is displayed depending on the "Direction". If the status is " Reserved", a "-" (hyphen) is
displayed.
- When the "Direction" is "From Local/To Remote"
The "Remote Box ID / Copy destination volume number" is displayed.
- When the "Direction" is "From Remote/To Local"
The copy destination volume name is displayed.
• Copy Range
The copy range of the copy session is displayed. If the status is " Reserved", a "-" (hyphen) is displayed.
- Totally
Whole volume
- Extent
Part of volume
• Secondary Access Permission
If the status is " Active", accessibility from the host to the copy destination volume is displayed. If the
status is " Reserved", a "-" (hyphen) is displayed.
- Read Only at Equivalency
When the "Phase" is "Equivalent", only read access to the copy destination volume is allowed
- No Read/Write
No read/write access to the copy destination volume is allowed
• Sync
The operation mode of the copy session is displayed. If the status is " Reserved", a "-" (hyphen) is dis-
played.
- Sync (synchronous)
- Async (asynchronous)
• Transfer Mode
The transfer mode of the copy session is displayed. If the "Status" is " Reserved", a "-" (hyphen) is dis-
played. If the "Sync" is "Sync", a "-" (hyphen) is displayed.
- Stack Mode (Asynchronous Stack mode)
- Consistency Mode (Asynchronous Consistency mode)
- Through Mode (Asynchronous Through mode)
• Recovery Mode
The recovery mode of the copy session is displayed. If the status is " Reserved", a "-" (hyphen) is dis-
played.
- Automatic Recovery
In this mode, copy automatically resumes when the copy path is recovered from error status.
- Manual Recovery
In this mode, copy does not automatically resume when the copy path is recovered from error status.