Appendix C Setting Procedures for Replacing HBAs
C.4 Required Storage System Settings After HBA Replacement (When Host Affinity Settings are Used)
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
420
2-6 Click the [OK] button.
Changing of the FC host starts.
2-7 Click the [Done] button to return to the [FC/FCoE Host] screen.
2-8 Confirm that the WWN is successfully changed.
This ends the host affinity setting for replacing an HBA.
Recover the multipath configuration from the host.
After recovering the multipath configuration, confirm that the ETERNUS DX/AF can be accessed from the host.
If the WWN is changed by the [Modify FC/FCoE Host] function, changing the host affinity setting is not
required.
To Next Page
Loading...
