Setting Items Description
Check connection (Ping)
(page 226)
Check the communication status between the scanner
and the connected computer.
Paper Source/Feeding
(page 227)
Pre-Pick (page 227) Enable this to shorten the scanning time when
scanning continuously.
Retry Paper Feeding
(page 227)
Specify the number of feeding retries when a
document is not fed from the ADF paper chute
(feeder).
Multifeed Detection (page
227)
Configure the settings to detect overlapped
documents during a scan.
Multifeed Detection Area
(page 229)
Specify an area to detect overlapped documents.
Intelligent Multifeed
Detection (page 230)
Configure the setting to automatically ignore certain
patterns of overlapped documents when the setting
to detect overlapped documents is enabled.
Manual Feeding (page
231)
Configure the settings when manually loading and
scanning one sheet at a time.
High Altitude Mode (page
231)
Enable this mode to use the scanner at an altitude of
2,000 m or higher.
Paper Protection (page
232)
Paper Protection (page
232)
Configure the setting to detect feeding errors.
Paper Protection (Touch
Screen Settings) (page
233)
Enable this option when you want some settings to
be prioritized over the settings for [Paper Protection]
and the Software Operation Panel.
Prioritize the touch screen
settings (page 233)
Image (page 234) Automatic Page Size
Detection (page 234)
When the scanner is set to detect the paper size
automatically, specify whether or not to optimize
(round up/down) the fractional part of the scanned
image.
Page Edge Filler Area
(page 234)
Configure the settings to fill in the shadow or streaks
around the edge of the scanned image.
Dropout Color (page 235) You can exclude a color from being scanned by
selecting either red, green, or blue (three primary
colors).
Offset (page 236) Specify a starting position for scanning.
Magnification (page 237) Specify the magnification level for the feed direction.
Scanner Settings (Touch Screen)
217
To Next Page
Loading...
Need help?
General
