b Grab the tabs on the pick rollers (× 2) to pull the pick rollers off the rotating shaft.
5 Install a new set of pick rollers (× 2) in the scanner.
a Place the pick rollers (× 2) on the shaft.
b Close the roller cover.
Make sure that both ends of the cover are locked firmly.
6 Close the ADF.
For details, refer to How to Close the ADF (page 28).
Be careful not to get your fingers caught when closing the ADF.
ATTENTION
● Do not close the ADF while the roller cover is open.
● Confirm that the pick rollers are installed properly. When the pick rollers are not installed properly, it
causes feeding errors such as paper jams.
7 Plug in the power cable and turn on the scanner.
For details, refer to How to Turn the Power ON (page 19).
Replacing the Consumables
140
To Next Page
Loading...
