Scanner Cleaning Cycle [Cleaning Cycle]
You can specify the cleaning cycle for the scanner.
The background color of the counter changes to yellow when the page count after cleaning reaches 100% of the
value specified here.
You can also configure settings to display the Message for cleaning (page 219).
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Cleaning Cycle].
3 Specify a value for the cleaning cycle.
The value can range from 1,000 to 255,000 sheets (in increments of 1,000).
Also specify whether or not to display the cleaning message.
Operational Settings
221
To Next Page
Loading...
