Replacing the Pick Roller
Replace the pick roller in following procedure.
HINT
There are two pick rollers. Make sure to replace both units.
1 Turn off the scanner, unplug the power cable and wait for at least 15 minutes.
For details, refer to How to Turn the Power OFF (page 21).
2 Remove all documents from the stacker.
3 Open the ADF.
For details, refer to How to Open the ADF (page 26).
When the ADF is open, it might close accidentally. Be careful not to get your fingers
caught.
4 Remove the pick rollers (× 2) from the scanner.
a Open the roller cover.
Grab the tabs on the left and right side with your fingers and pull down the cover towards you.
Replacing the Consumables
139
To Next Page
Loading...
