Setting Automatic Detection for Color/Monochrome [Auto color Detection]
Specify the slice level for Auto Color Detection.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the listing on the left, select [Device Setting 2] → [Auto color Detection].
3 Select the slice value.
You can select the Slice value from 1 to 255.
Increase the value when black & white documents are recognized as color documents.
Decrease the value when color documents are recognized as black & white documents.
HINT
For information on how to configure the automatic color/monochrome detection, refer to the help for the
scanner driver.
Operational Settings
237
To Next Page
Loading...
