Specifying an Area Not to Detect Multifeed [Intelligent Multifeed Function]
When there is paper of the same size attached to a designated location on the page, the scanner can memorize the
location of the attachment and can be configured not to detect multifeeds for that location. To configure this
setting, you first need to select [Check Overlapping (Ultrasonic)] for the multifeed detection setting in Specifying a
Multifeed Detection Method [Multifeed] (page 252) or the scanner driver's setup dialog box.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Intelligent Multifeed Function].
3 Select an operation mode and click the [OK] button.
Mode Description
Manual mode Specify whether to stop feeding the documents when
a multifeed is detected or resume the scan by
loading the documents back on the hopper.
The size and location of the paper attachment are
not memorized.
Auto mode 1 Specify whether to memorize the length and position
of a piece of paper that is attached on a document
when a multifeed is detected.
Operational Settings
261
To Next Page
Loading...
