Item Configurable in Function Selection
Item Description Setting Factory
Default
Function
Selection
Configure the application(s) to be launched by
the [Send to] button.
It displays the scanner button events configured
in the computer ([Send to 1] to [Send to 50]).
For information on how to configure scanner
button events, refer to Using a Button on the
Scanner to Start Scanning (page 108).
No.01 to No.50/No.C
(No.C indicates the Software
Operation Panel.)
(*1)
*1:Although there is no factory default setting, it is set to [No.01] when you turn on the power. Therefore, the
setting does not change even when you initialize the operator panel.
How to Use the Operator Panel
97
To Next Page
Loading...
