Resuming from Power Saving Mode
Power saving mode keeps the power consumption low when the scanner has not been used for a certain period of
time.
If the scanner is left powered on for 15 minutes or more without being used, it automatically enters power saving
mode.
When it enters power saving mode, the LCD on the operator panel turns off. The power button remains lit in blue.
To resume from power saving mode, perform one of the following:
● Load a document on the hopper.
● Press any button (except for power button) on the operator panel.
Note that the scanner will be turned off when you press the power button for more than two seconds.
● Scan a document with the image scanning application.
Also, the scanner can be set to turn itself off automatically when it is turned on and left unused for a certain period
of time.
You can save the power consumption by having the scanner turn off automatically.
To enable this setting, select the [Power off after a certain period of time] check box in [Device Setting] of the
Software Operation Panel.
For details, refer to Setting the Waiting Time to Enter Power Saving Mode [Power saving] (page 264).
To turn the scanner back on after it is automatically turned off, press the power button on the scanner.
For details, refer to How to Turn the Power ON (page 19).
ATTENTION
● Depending on the application you are using, the scanner may not be turned off automatically even when the
[Power off after a certain period of time] check box is selected.
● If the scanner turns itself off automatically while you are using an image scanning application, close the
application first, then turn the scanner back on.
HINT
The waiting time for entering power saving mode can be changed in the Software Operation Panel.
For details, refer to Setting the Waiting Time to Enter Power Saving Mode [Power saving] (page 264).
Scanner Overview
39
To Next Page
Loading...
