Basic Flow of the Scanning Operation
This section explains the basic flow of scanning operations.
In order to perform a scan, you need a scanner driver and an application that supports the scanner driver.
The following scanner drivers and image scanning applications are bundled with the scanner:
● Scanner driver
- PaperStream IP driver
● Image scanning application
- PaperStream Capture
- PaperStream Capture Pro (Trial)
HINT
● For details about the scanner driver and image scanning applications, refer to Overview of the Bundled
Software (page 42).
● Scanning procedures, operations, and scan setting items slightly vary depending on the image scanning
application and the scanner driver.
For details, refer to the manual or help for the image scanning application, and the help for the scanner driver.
1 Turn on the scanner.
For information on how to turn on the power, refer to How to Turn the Power ON (page 19).
2 Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
For information on how to load documents, refer to How to Load Documents (page 47).
3 Start an image scanning application.
4 Select a scanner driver to be used for scanning.
For some image scanning applications, selection of a scanner driver may not be needed.
5 Select a scanner.
Make sure to select the scanner model that is connected to the computer.
For some image scanning applications, selection of a scanner may not be needed.
Scanner Overview
40
To Next Page
Loading...
