Fujitsu fi-7900 - How to Load Documents; Setting the Documents at the Center of the Hopper

How to Load Documents
There are two ways to load the documents.
Setting the documents at the center of the hopper
This style is used mainly when the documents are of the same size.
Setting the documents by the left or right side of the hopper
This style is used mainly when the documents are in different sizes or when you want to shift the center of the
documents.
ATTENTION
Note that different conditions apply for multifeed detection when you set the documents by either left or right
side of the hopper.
Setting the Documents at the Center of the Hopper
1 Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
HINT
● Make sure to keep the documents within the maximum load line on the inside of the hopper side
guides.
How to Load Documents
49