Resetting the Sheet Counters
When you have replaced the consumables or performed cleaning, reset the corresponding counters as follows:
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting] and click the [Clear] button for [After cleaning] when
cleaning is performed or click the [Clear] button for the consumable that you replaced.
The counter value is reset to 0.
For ink level, it is reset to 100.
ATTENTION
The assist roller counter cannot be cleared.
It requires a service engineer to clear the counter.
For details, contact a service engineer. Refer to the contact information in the Contact List or the Contact
for Inquiries section in Safety Precautions bundled with this product and make an inquiry.
3 In the Software Operation Panel, click the [OK] button.
Operational Settings
218
To Next Page
Loading...
