Password Setting for the Software Operation Panel
By setting a password, the Software Operation Panel can run in [View Only mode] which allows users to only
view the scanner settings.
The scanner settings can be configured if no password is set.
In order to prevent unnecessary changes to the settings, a password can be used to restrict user operations.
Setting a Password
Set a password in the following procedure.
1 Right-click the Software Operation Panel icon on the taskbar, and select [Password Setting] from the
menu.
The [Password setting] window appears.
2 Enter a new password then again to confirm, and click the [OK] button.
Up to 32 characters can be used for the password.
Note that only alphanumeric characters (a to z, A to Z, 0 to 9) are allowed.
A message window appears.
3 Click the [OK] button.
The password is set.
Operational Settings
195
To Next Page
Loading...
