Errors
● Error Code
When an error occurs in the scanner, the Check LED lights in orange and an error code appears on the LCD of
the scanner's operator panel.
You can clear the error display by pressing the [Clear/Back] or the [Stop] button.
Note that for a paper jam, the message disappears after a certain amount of time elapses with no documents
([Ready] status) in the scanner.
ATTENTION
When you scan a lot of documents written with lead pencil, the following message may appear: " Clean the
consumables (brake roller, separator roller and pick roller) because they may be dirty. Also try pressing the
button to lower the paper separation force when [Ready] is displayed. If this message keeps on
appearing, replace the consumables. Refer to the manual for information on how to clean or replace the
consumables. "
This message only appears on the operator panel without an error code.
Troubleshoot as instructed in the message.
Troubleshooting
156
To Next Page
Loading...
