● Errors such as multifeed, pick error and paper jam may also be caused by worn-out consumables or
contamination in the feeding mechanism. If these symptoms do not improve after changing the paper
separation force, either replace the consumables or clean the inside of the scanner.
● Documents may be damaged if the paper separation force is set too high.
In that case, set the paper separation force lower.
● When the automatic separation control is enabled, even if the paper separation force is adjusted manually, the
paper separation force may be controlled automatically.
● [Paper Separation Force] can also be displayed by shortcut key. To display the [Paper Separation Force] screen
by shortcut key, press the [ ] or [ ] button when [Ready] is displayed.
Change the paper separation force by using the [ ] or [ ] button.
When [Paper Separation Force] is displayed by shortcut key, the screen returns to [Ready] after a certain period
of time.
This period of time can be configured in [18: Operation Panel Timeout] of the operator panel.
Scanner Overview
38
To Next Page
Loading...
