Mode Description
Once memorized, when a paper attachment of a
similar pattern is detected, the scanner ignores it to
suppress multifeed detection.
Auto mode 2 Specify whether to memorize the length of the
longest piece of paper that is attached on a
document when a multifeed is detected.
Once memorized, when a paper attachment of the
same length or shorter is detected, the scanner
ignores it to suppress multifeed detection.
HINT
● By selecting the [Clear overlap pattern] check box, you can erase the overlapping patterns (length,
position) that were memorized in Auto mode.
● By selecting the [Auto-Memorize MF Pattern (only when MF images are displayed)] check box, you can
have the multifeed pattern memorized in the window that shows the multifeed images.
● In [Remember multifeed pattern at power-off], you can select whether or not to memorize the multifeed
pattern upon turning the power off. When [Remember] is selected, you can use the memorized
multifeed pattern when the scanner is powered on next.
● This setting can also be configured from the operator panel.
For information about the procedure after this step, refer to Bypassing Multifeed Detection for a Fixed Format
(page 111).
Operational Settings
262
To Next Page
Loading...
