CHAPTER 4
ETSI Configuration
Storing, Unpacking, and Inspecting Equipment
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-12
Fujitsu and Fujitsu Customer Use Only
9 Is there any noticeable damage to the rack?
If YES:
Go to Step 16 [p. 4-13].
If NO:
Continue with Step 10 [p. 4-12].
Note: The equipment rack should be completely covered with shrink wrap to prevent damage during
shipment.
10 At the side of the rack, use industrial shears to cut open the shrink wrap. Start cutting from
the bottom of the rack to the top.
Always cut at the side of the rack to avoid damaging the equipment. Standard
configuration racks are delivered prewired. Do not cut or disconnect any wires.
11
Carefully remove the shrink wrap from the rack.
12 Is there any noticeable damage to the rack after the shrink wrap is removed?
If YES:
Go to Step 16 [p. 4-13].
If NO:
Continue with Step 13 [p. 4-12].
13 Does the rack contain equipment (standard rack configuration)?
If YES:
Continue with Step 14 [p. 4-12].
If NO:
Go to Step 18 [p. 4-13].
14 Locate the serial numbers on the left side of each equipment shelf mounted in the rack, and
compare the serial numbers with the serial numbers on the shipping documents.
To Next Page
Loading...