CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-44
Fujitsu and Fujitsu Customer Use Only
Note: Fujitsu recommends that you install the ETSI rack cover panels from bottom to top, in
ascending order, for an easier installation.
1 If not already done, unpack the three covers and mounting hardware from the shipping
container.
2 Remove and discard the four mounting screws from the lower FLASHWAVE 7500 shelf (see
Figure 4-26 [p. 4-44]).
Figure 4-26: Lower Cover Mounting Screw Locations
r1418_1
Remove and discard mounting
screws from these locations.
To Next Page
Loading...