CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-54
Fujitsu and Fujitsu Customer Use Only
7 Align the tabs on the bottom of the middle panel with the slots on the top edge of the lower
panel installed. Secure the panel by tightening the two captive panel screws using the Hex
Torx pin tool provided in the kit. See Figure 4-37 [p. 4-54].
Figure 4-37: Securing the Middle Cover Panel
r1429_1
Insert tab into slot
in top of lower cover
(2 places).
Secure panel by fastening
captive screw on panel
to pin/socket standoff
using supplied special tool
(2 places).
To Next Page
Loading...