CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-58
Fujitsu and Fujitsu Customer Use Only
10 Position the keyholes in the ETSI upper cover panel over the hook of the upper two standoffs.
Let the panel drop down in the slot formed by the hook. Secure the panel in place by
tightening the two lower captive panel screws using the Hex Torx tool provided in the ETSI
Rack Cover Kit. See Figure 4-42 [p. 4-59].
Figure 4-41: Upper Cover Mounting Screws/Standoffs without Upper FLASHWAVE 7500 Shelf
r1433_1
Install in top two indicated locations:
2 PC210-0001-X028 standoffs, pin/hook
2 D4-WTE250-33 external tooth washers
2 D4-WP250N-33 flat washers
Install in bottom two indicated locations:
2 PC210-0001-X027 standoffs, pin/socket
2 D4-WTE250-33 external tooth washers
2 D4-WP250N-33 flat washers
To Next Page
Loading...