CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing Filler Panels
6-11
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
1 If not already done, unpack the required number of filler panels from the shipping container.
Waiting until the shelf is fully populated at system turn-up may be necessary to determine the
unused equipment slots.
2 Install each filler panel in an unused equipment slot as follows:
a. Carefully slide the plug-in unit into the appropriate shelf slot, ensuring that the guides
mesh properly into the grooves of the shelf.
b. Gently push the faceplate as shown in Figure 6-6 [p. 6-11] to seat the filler panel.
This procedure is complete.
Figure 6-6: Insert Filler Panel
To Next Page
Loading...