Fujitsu FLASHWAVE 7500 - Page 374

CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing SFP Modules in a Muxponder or Flexponder™ Unit
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-12
Fujitsu and Fujitsu Customer Use Only
6.5 Installing/Removing SFP Modules in a Muxponder or
Flexponder™ Unit
NO.SUBPROCEDURE PAGE
This procedure includes the following subprocedures: Procedure
6.5.1 Removing an SFP Module from a Muxponder or Flexponder Unit . . . . . . . . . . . . . . . . 6-12
6.5.2 Installing an SFP Module in a Muxponder or Flexponder Unit. . . . . . . . . . . . . . . . . . . . 6-17
The following procedures are used for removing and installing small form-factor pluggable
(SFP) modules.
6.5.1 Removing an SFP Module from a Muxponder or Flexponder Unit
This procedure lists the steps for removing an SFP module in an IFMA-8TCx or
IFMA-GUC1 (muxponder) plug-in unit or an IFMA-BUC1 or IFMA-BXC1 (Flexponder)
plug-in unit.
Observe the following precautions when removing and installing all plug-in units:
DANGER:
Never look into the end of a fiber-optic cable. Permanent eye damage or blindness can
occur very quickly if the laser light is present. Follow local safety precautions regarding
fiber.
DANGER:
Never handle exposed fiber with bare hands or touch it to your body. A fiber fragment
could enter the skin and be very difficult to detect and remove. Follow local safety
precautions regarding fiber.
CAUTION:
Do not remove the wrong fiber connections. Removing a fiber connection that is in use will
disrupt service.
Perform the following steps to remove the SFP module:
Step Task
1 Locate the muxponder/Flexponder plug-in unit that contains the SFP module to be removed.
Revision 1, June 2009