Fujitsu FLASHWAVE 7500 - Page 379

CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing SFP Modules in a Muxponder or Flexponder™ Unit
6-17
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
6.5.2 Installing an SFP Module in a Muxponder or Flexponder Unit
This procedure lists the steps for installing an SFP module in an IFMA-8TCx or
IFMA-GUC1 (muxponder) plug-in unit or an IFMA-BUC1 or IFMA-BXC1 (Flexponder)
plug-in unit.
DANGER:
Never look into the end of a fiber-optic cable. Permanent eye damage or blindness can
occur very quickly if the laser light is present. Follow local safety precautions regarding
fiber.
DANGER:
Never handle exposed fiber with bare hands or touch it to your body. A fiber fragment
could enter the skin and be very difficult to detect and remove. Follow local safety
precautions regarding fiber.
CAUTION:
Do not remove the wrong fiber connections. Removing a fiber connection that is in use will
disrupt service.
Revision 1, June 2009