CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing SFP Modules in a Muxponder or Flexponder™ Unit
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-18
Fujitsu and Fujitsu Customer Use Only
Perform the following steps to install the SFP module:
1 Inspect the SFP module (see Figure 6-11 [p. 6-18]) for damage or debris, and remove the
optical connector cover.
2 Locate the muxponder/Flexponder plug-in unit that will contain the SFP module being
installed.
3 If necessary, record the serial number and issue number of the module being installed.
4 Install the module into the proper SFP slot of the muxponder/Flexponder plug-in unit.
5 Will fibers be connected to the module at this time?
If YES:
Continue with Step 6 [p. 6-18].
If NO:
Go to Step 9 [p. 6-19].
6 Clean the optical connectors. Refer to Fiber Cable Handling.
7 Connect the fiber-optic cables to the SFP module.
Figure 6-11: SFP Module with Optical Connector Cover Removed
To Next Page
Loading...