CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing SFP Modules in a Muxponder or Flexponder™ Unit
6-19
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
8 Was the module installed in a muxponder unit?
If YES:
Continue with Step 9 [p. 6-19].
If NO:
Proceed to Step 10 [p. 6-19].
9 For a muxponder plug-in unit, close the stainless steel client connection drawer (see
Figure 6-8 [p. 6-14]), and gently tighten the two thumb screws that secure it on the front of
the muxponder plug-in unit.
10 For a Flexponder plug-in unit, lower the hinged door to cover the front of the plug-in unit, if
present.
Note: Older versions of the IFMA-BUC1 unit have the hinged door. Newer versions of the IFMA-BUC1
unit do not have a hinged door. The IFMA-BXC1 unit does not have a hinged door.
This procedure is complete.
To Next Page
Loading...