Fujitsu FLASHWAVE 7500 - Page 382

CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing XFP Modules in a 4:1 10G Muxponder Unit
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-20
Fujitsu and Fujitsu Customer Use Only
6.6 Installing/Removing XFP Modules in a 4:1 10G Muxponder
Unit
NO.SUBPROCEDURE PAGE
This procedure includes the following subprocedures: Procedure
6.6.1 Removing an XFP Module from a 4:1 10G Muxponder Unit . . . . . . . . . . . . . . . . . . . . . . 6-20
6.6.2 Installing an XFP Module in a 4:1 10G Muxponder Unit . . . . . . . . . . . . . . . . . . . . . . . . . . 6-21
The following procedures are used for removing and installing 10G small form-factor
pluggable (XFP) modules:
6.6.1 Removing an XFP Module from a 4:1 10G Muxponder Unit
This procedure lists the steps for removing an XFP module from an IFMA-QMC1
(muxponder) plug-in unit.
Observe the following precautions when removing and installing all plug-in units:
DANGER:
Never look into the end of a fiber-optic cable. Permanent eye damage or blindness can
occur very quickly if the laser light is present. Follow local safety precautions regarding
fiber.
DANGER:
Never handle exposed fiber with bare hands or touch it to your body. A fiber fragment
could enter the skin and be very difficult to detect and remove. Follow local safety
precautions regarding fiber.
CAUTION:
Do not remove the wrong fiber connections. Removing a fiber connection that is in use will
disrupt service.
Perform the following steps to remove the XFP module:
Step Task
1 Locate the muxponder plug-in unit that contains the XFP module to be removed.
Revision 1, June 2009