CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing XFP Modules in a 4:1 10G Muxponder Unit
6-21
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
2 Locate the XFP module to be removed, and inspect the fiber connections to it (if any). Verify
that each fiber is clearly marked or labeled to identify the connector to which it connects.
Note: Fiber marking or labeling depends on local practice.
3 Is each fiber clearly marked to show the connector to which it connects?
If YES:
Continue to Step 4 [p. 6-21].
If NO:
Mark or label fibers according to local practice. Then repeat this step.
4 Disconnect the fiber-optic cables from the XFP module to be removed.
5 To remove the XFP module from the plug-in unit, press the detent button on the left side of
the XFP module to release the XFP module from the plug-in unit, and then pull the XFP
module straight out.
6 Carefully install optical connector covers into the XFP module.
7 Set the module aside for repair paperwork processing.
8 Is another XFP module being installed in the same position?
If YES:
Continue to Step 9 [p. 6-21].
If NO:
Proceed to Step 10 [p. 6-21].
9 If necessary, record the serial number and issue number of the replacement XFP module, and
then proceed to Section 6.6.2 [p. 6-21].
10 Close the stainless steel client connection drawer (see Figure 6-8 [p. 6-14]), and gently tighten
the two thumb screws that secure it on the front of the muxponder plug-in unit.
This procedure is complete.
6.6.2 Installing an XFP Module in a 4:1 10G Muxponder Unit
This procedure lists the steps for installing an XFP module in an IFMA-QMC1(muxponder)
plug-in unit.
To Next Page
Loading...