CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing XFP Modules in a 4:1 10G Muxponder Unit
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-22
Fujitsu and Fujitsu Customer Use Only
Never look into the end of a fiber-optic cable. Permanent eye damage or blindness can
occur very quickly if the laser light is present. Follow local safety precautions regarding
fiber.
Never handle exposed fiber with bare hands or touch it to your body. A fiber fragment
could enter the skin and be very difficult to detect and remove. Follow local safety
precautions regarding fiber.
Do not remove the wrong fiber connections. Removing a fiber connection that is in use will
disrupt service.
Perform the following steps to install the XFP module:
1 Inspect the XFP module (see Figure 6-12 [p. 6-22]) for damage or debris, and remove the
optical connector cover.
2 Locate the muxponder plug-in unit that will contain the XFP module being installed.
Figure 6-12: Detent Button (Blue) on Front of XFP Module
To Next Page
Loading...