About Actions (for Windows Users)
147
3. Change settings for the [Rack2-Filer] action (If you do not want to
change settings, go to Step 4.).
1. Click the [Application Settings] button.
⇒The [ScanSnap -> Rack2] dialog box appears.
2. Change settings.
In this dialog box, specify the destination to save the scanned image data.
For details about the [ScanSnap -> Rack2] dialog box, refer to Rack2-Filer Help.
Click the [Help] button in the [ScanSnap -> Rack2] dialog box to display Rack2-Filer
Help.
3. Click the [OK] button to close the [ScanSnap -> Rack2] dialog box.
4. Click the [OK] button to close the ScanSnap setup dialog box.
Even if the [Scan] button on the ScanSnap is pressed, the ScanSnap setup dialog box
closes.
To Next Page
Loading...
