120
Step 1 Select Setting > Event > Smart Track > Alarm Track.
The Alarm Track interface is displayed. See Figure 5-12.
Figure 5-12 Alarm track
Step 2 To enable track linkage, select the Enable check box.
Manual positioning and manual track are enabled after Alarm Track is enabled.
Auto Track is enabled after Alarm Track and Auto Track are enabled.
Step 3 Set parameters. See Table 5-3.
Table 5-3 Description of alarm track parameters
Select On, the speed dome would automatically links to a corresponding
position and tracks an object when the intelligent rules of the panoramic
camera trigger alarms.
Set the alarm track time.
Before an object disappears: The speed dome would automatically
links to a corresponding position and tracks an object until the object
moves out of the monitoring range when the intelligent rules of the
panoramic camera trigger alarms.
Custom: Set the auto alarm track time of the speed dome.
It is an interval from the end of alarm track of the speed dome to the start of
idle mode.
Set Idle Time and Idle Position. If no event needs to be tracked after the
configured idle time, the device automatically rotates to the set idle position.
For example, the Idle Time is set to be five seconds and the Idle Position
is set to be preset point 1. When the speed dome does not start tracking
after five seconds, it automatically rotates to preset point 1.
To set Idle Position, first set a preset point. For preset point, see "4.3.2.1
Preset."
Step 4 Click Save.
To Next Page
Loading...
Need help?
General