128
5.7 Setting Smart Plan
Smart plan includes face detection, heat map, IVS, people counting, face detection, video
structuralization, and stereo analysis. The intelligent function can be enabled only after the
corresponding smart plan is enabled.
Step 1 Select Setting > Event > Smart Plan.
The Smart Plan interface is displayed. For smart plan icon, see Table 5-4.
Table 5-4 Description of smart plan icon
Step 2 Enable smart functions as need.
Different cameras support different ways to enable smart functions. Select
corresponding ways to enable these functions according to the actual interface.
Select an icon to enable the corresponding smart plan.
Click an icon to enable it, and the selected smart function is highlighted. Click it
again to cancel the selection.
If there is icon on the interface, click it to enable the smart function
switch.
Enable smart plan through Add Plan.
1) Select a preset point from the Add Plan the interface.
The smart plan for the point is displayed.
2) To enable a smart function, click the corresponding icon.
The selected smart function is highlighted. Click it again to cancel the
selection.
Step 3 Click Save.
5.8 Setting IVS
This section introduces scene selection requirements, rule configuration, and global
configuration for IVS (intelligent video surveillance).
Basic requirements on scene selection are as follows.
The target should occupy no more than 10% of the whole image.
To Next Page
Loading...
Need help?
General