87
4.7.3 Setting Destination
This section introduces the configuration of the storage method for the recorded videos and
snapshots.
4.7.3.1 Path
You can select different storage paths for the recorded videos and snapshots according to
event type. You can select from SD card, FTP and NAS.
Local is displayed only on models that support SD card.
Step 1 Select Setting > Storage > Destination > Path.
The Path interface is displayed. See Figure 4-84.
Figure 4-84 Path
Step 2 Select the storage method that you need for the recorded videos and snapshots of
different types.
Table 4-32 Description of path parameters
Select from Scheduled, Motion Detection and Alarm.
Save in the internal SD card.
Save in the NAS (network attached storage).
Step 3 Click Save.
Step 4 Configure other path parameters on Destination, FTP or NAS interface. For details,
see "4.7.3 Setting Destination", "4.7.3.3 FTP" or "4.7.3.4 NAS."
4.7.3.2 Local
Display the information of the local SD card. You can set it as read only or read & write; you can
also hot swap and format SD card, and reset password for it. There are 3 modes according to
the SD card status:
Normal mode: The new SD cards and the cards whose password are cleared successfully
show normal mode. The SD cards of this status do not support authorization operation.
Unauthorized mode: The SD card authorized by other devices shows unauthorized mode.
The SD cards of this status do not support operations of setting read only, read & write,
formatting and encryption.
To Next Page
Loading...
Need help?
General