Garmin GNC 355 - Flight Plan Waypoint Options

Navigation
190-02488-01 Rev. B Pilot’s Guide 3-39
Flight Plan Waypoint Options
Insert Before Insert a new waypoint before the selected waypoint.
Insert After Insert a new waypoint after the selected waypoint.
Load PROC
Open the Procedures app to specify a departure, arrival,
or approach for loading. Available controls are dependent
upon the relative position of the aircraft to the active flight
plan. Options may include: • Activate Approach
• Vectors to Final • Activate Missed Approach
Load Airway
Assign an airway and exit waypoint to the selected entry
waypoint (e.g., intersection, VOR).
Activate Leg
Designate any TO waypoint as the active flight plan leg.
Requires an active catalog flight plan.
Hold at WPT
Create a user-defined hold at the selected waypoint.
Specify hold parameters and preview holding patterns
from a dedicated menu page.
WPT Info
Open the dedicated information page for the selected
waypoint.
Remove
Remove the selected waypoint or hold from the active
flight plan.
You may also set a direct-to course to any existing waypoint in the active flight
plan. Select an identifier and tap the Direct To key.
For details about Direct To features, refer to Direct To Basics.
Selecting a waypoint identifier opens a menu.
Changes to the active flight plan take effect
immediately.
• Insert a new waypoint into a flight plan
• Add an airway or procedure
• Change the active leg
• Remove a selected waypoint
• Add a holding pattern to an existing waypoint
• View information about a waypoint
InsertAfter
InsertBefore
LoadPROC
OptionsMenu
LoadAirway
ActivateLeg
HoldatWPT
WPTInfo
Remove