This feature delays both video and audio output by the
amount of time (in sec.) set to allow the projector/display to
sync with the video output of the Server.
When this option is enabled, subtitles are displayed using
server rendering. When this option is disabled, CineCanvas is
used for subtitle display.
Enter a Subtitle Delay in number of frames, entering a
negative number will advance the subtitles by that number of
frames.
Send a SMPTE-compatible Resource Presentation List (RPL)
instead of an Interop-compatible Subtitle
Presentation List to the projector for CineCanvas subtitles.
This is only enabled when SMPTE subtitles are available
for the CPL.
This drop-down allows selection of the network interface
which should be used for providing CineCanvas subtitles to
the Projector. The following network interfaces are available:
•
Auto
•
Internal
•
IMB Ethernet 2
By default; the Auto option is selected, which should work in
most cases.
Timeout (in sec.) for communication with the projector.
Select the blank time (in sec.) of the projector during change
of PCF or format. This is to prevent noise when the PCF
or format is changed.
To Next Page
Loading...
