GE Krautkramer USM 35X - UNIT (Selecting Units of Measurement)

5-54 Issue 01, 04/2005 Krautkramer USM 35X
Operation
• Spanish
• Portuguese
• Dutch
• Swedish
• Slovenian
• Romanian
• Finnish
• Czech
• Danish
• Hungarian
• Croatian
• Russian
• Slovakian
• Norwegian
• Polish
• Japanese
H Note:
More dialog languages can be added on request.
– Select the function DIALOG.
– Use the right-hand rotary knob to select the required
language.
General configuration
UNIT (Selecting units of measurement)
You can choose the required units between mm or inch
in the function UNIT.
A Attention:
You should always make your decision on the units
immediately when starting to work with the USM 35X. If
you change the unit, all current settings are deleted,
and the basic setup is loaded.
– Select the function UNIT.
– Use the right-hand rotary knob to select the required
unit.
To avoid any accidental deleting of values, the
measurement line will display a safety prompt:
Change unit?
– If you are sure that you want to change the unit of
measurement, press the corresponding key of the
function UNIT. Any other key would abort the process.
The unit of measurement is now changed; the current
data are deleted.
5-54 Issue 01, 04/2005 Krautkramer USM 35X
Operation
• Spanish
• Portuguese
• Dutch
• Swedish
• Slovenian
• Romanian
• Finnish
• Czech
• Danish
• Hungarian
• Croatian
• Russian
• Slovakian
• Norwegian
• Polish
• Japanese
H Note:
More dialog languages can be added on request.
– Select the function DIALOG.
– Use the right-hand rotary knob to select the required
language.
General configuration
UNIT (Selecting units of measurement)
You can choose the required units between mm or inch
in the function UNIT.
A Attention:
You should always make your decision on the units
immediately when starting to work with the USM 35X. If
you change the unit, all current settings are deleted,
and the basic setup is loaded.
– Select the function UNIT.
– Use the right-hand rotary knob to select the required
unit.
To avoid any accidental deleting of values, the
measurement line will display a safety prompt:
Change unit?
– If you are sure that you want to change the unit of
measurement, press the corresponding key of the
function UNIT. Any other key would abort the process.
The unit of measurement is now changed; the current
data are deleted.