GE Krautkramer USM 35X - Configuring the Measurement Line

Krautkramer USM 35X Issue 01, 04/2005 5-49
Operation
• afreeze/bfreeze (automatic freeze)
Whenever you select this function, an echo display
connected with the A or B gate will automatically
switch over to A-scan freeze (automatic freeze). This
setting is especially well suited e.g. for high-tempera-
ture measurements, for measurements involving
difficult coupling conditions, or for spot weld testing.
H Note:
If you are using a Data Logger option, you also have
the function cfreeze (for C gate) at your disposal.
– Select the function A-SCAN.
– Use the right-hand rotary knob to choose the required
setting.
– Pay attention to the additional information referring to
the corresponding setting options (see preceeding
page).
Configuring the measurement line
The configuration of your measurement line is carried
out in the function group MSEL, this means that you
can choose the reading for one of the four possible
positions of the measurement line for direct measured-
value display during the test.
– If required, go to the third operating level.
– Select the function group MSEL.
Functions of the function group MSEL:
MEAS-P1 MEAS-P2 MEAS-P3 MEAS-P4
Measured values at positions 1 to 4
Configuring the USM 35X for a test application
Krautkramer USM 35X Issue 01, 04/2005 5-49
Operation
• afreeze/bfreeze (automatic freeze)
Whenever you select this function, an echo display
connected with the A or B gate will automatically
switch over to A-scan freeze (automatic freeze). This
setting is especially well suited e.g. for high-tempera-
ture measurements, for measurements involving
difficult coupling conditions, or for spot weld testing.
H Note:
If you are using a Data Logger option, you also have
the function cfreeze (for C gate) at your disposal.
– Select the function A-SCAN.
– Use the right-hand rotary knob to choose the required
setting.
– Pay attention to the additional information referring to
the corresponding setting options (see preceeding
page).
Configuring the measurement line
The configuration of your measurement line is carried
out in the function group MSEL, this means that you
can choose the reading for one of the four possible
positions of the measurement line for direct measured-
value display during the test.
– If required, go to the third operating level.
– Select the function group MSEL.
Functions of the function group MSEL:
MEAS-P1 MEAS-P2 MEAS-P3 MEAS-P4
Measured values at positions 1 to 4
Configuring the USM 35X for a test application