GE Krautkramer USM 35X - Function Groups Third Operating Level

5-4 Issue 01, 04/2005 Krautkramer USM 35X
Operation
or
DGS This function group serves for the ampli-
tude evaluation according to the DGS
method (only USM 35X S).
TRIG Combined in this group are the functions
required for angle beaming using angle-
beam probes for the display of a (reduced)
projection distance and depth position of a
reflector (for plane-parallel and circular
curved test components).
MEM These functions serve for storing, loading
and deleting of data sets.
DATA The functions of this group serve for the
dataset management and documentation.
Function groups third operating level
MEAS In this group, you can define the measuring
point, select a parameter for the zoomed
measured-value display in the A-scan as
well as for the setting of the Magnify func-
tion, and you can select different settings
for the A-scan.
MSEL This is where you configure your measure-
ment line. You can choose one display for
each of the four positions.
LCD This is the function group where you can
set the LCD contrast and backlight as well
as the echo display mode on the screen.
CFG1 Functions for the configuration: unit, dialog
language, printer driver and assignment of
the key
CFG2 Other functions for configuration: time and
date, alarm horn; plus the changeover
between the evaluation modes
Overview of the functions
5-4 Issue 01, 04/2005 Krautkramer USM 35X
Operation
or
DGS This function group serves for the ampli-
tude evaluation according to the DGS
method (only USM 35X S).
TRIG Combined in this group are the functions
required for angle beaming using angle-
beam probes for the display of a (reduced)
projection distance and depth position of a
reflector (for plane-parallel and circular
curved test components).
MEM These functions serve for storing, loading
and deleting of data sets.
DATA The functions of this group serve for the
dataset management and documentation.
Function groups third operating level
MEAS In this group, you can define the measuring
point, select a parameter for the zoomed
measured-value display in the A-scan as
well as for the setting of the Magnify func-
tion, and you can select different settings
for the A-scan.
MSEL This is where you configure your measure-
ment line. You can choose one display for
each of the four positions.
LCD This is the function group where you can
set the LCD contrast and backlight as well
as the echo display mode on the screen.
CFG1 Functions for the configuration: unit, dialog
language, printer driver and assignment of
the key
CFG2 Other functions for configuration: time and
date, alarm horn; plus the changeover
between the evaluation modes
Overview of the functions