5-56 Issue 01, 04/2005 Krautkramer USM 35X
Operation
• meas P1
The measured value given at position 1 in the
measurement line
• pardump
All instrument functions with the current settings
• PCX
Screen contents as a PCX-format file. To transfer the
data to the PC, you will need a terminal program.
• store
The current instrument setting is stored to the
selected (free) data set, and the data set number
(DAT-#) is automatically increased.
• datalog (only with Data Logger option)
The selected job is printed out as a report including
all measured values.
• off
The key is deactivated.
• special
as setting “hardcpy”. After printout of the screen
contents no form feed, every press on the key prints
out the next hardcopy on the same page (three or
four hardcopies depending on the printer).
H Note:
Please also refer to chapter 6
Documentation
.
– Select the function COPYMOD.
– Use the right-hand rotary knob to set the required
assignment for the key.
TIME/DATE (Setting the time and date)
You have to check the current date and time and, if
required, set them so that these data are correctly
saved together with the test results.
General configuration
5-56 Issue 01, 04/2005 Krautkramer USM 35X
Operation
• meas P1
The measured value given at position 1 in the
measurement line
• pardump
All instrument functions with the current settings
• PCX
Screen contents as a PCX-format file. To transfer the
data to the PC, you will need a terminal program.
• store
The current instrument setting is stored to the
selected (free) data set, and the data set number
(DAT-#) is automatically increased.
• datalog (only with Data Logger option)
The selected job is printed out as a report including
all measured values.
• off
The key is deactivated.
• special
as setting “hardcpy”. After printout of the screen
contents no form feed, every press on the key prints
out the next hardcopy on the same page (three or
four hardcopies depending on the printer).
H Note:
Please also refer to chapter 6
Documentation
.
– Select the function COPYMOD.
– Use the right-hand rotary knob to set the required
assignment for the key.
TIME/DATE (Setting the time and date)
You have to check the current date and time and, if
required, set them so that these data are correctly
saved together with the test results.
General configuration
To Next Page
Loading...
