GE Krautkramer USM 35X - Printing Data; Preparing the Printer; Preparing the USM 35 X

6-2 Issue 01, 04/2005 Krautkramer USM 35X
Documentation Printing data
6.1 Printing data
Direct printing of the following data via the RS 232
interface is possible using the USM 35X:
• test report containing the A-scan and the adjustment
data
• A-scan
• single reading (position 1 of the measurement line)
• function list (including all current settings)
• Data Logger (if the version is available)
To do this, you need
• a printer with serial interface RS 232
• a printer cable (please see chapter 2)
Preparing the printer
The transfer parameter settings for the serial port are:
• Baud rate 0 (no transmission), 300, 600, 1200,
2400, 4800, 9600 (default), 19200,
38400, and 57600
• Word length 8 data bits (fixed)
• Parity none (fixed)
• Stop bits 2 (fixed)
In order to ensure a perfect communication, set the
printer to the parameters of the USM 35X.
Preparing the USM 35X
You decide on the type of printout by assigning the
key.
– If necessary, go to the third operating level.
– Select the function group CFG1.
– Select the function PRINTER, and then use the right-
hand rotary knob to select the correct printer driver.
6-2 Issue 01, 04/2005 Krautkramer USM 35X
Documentation Printing data
6.1 Printing data
Direct printing of the following data via the RS 232
interface is possible using the USM 35X:
• test report containing the A-scan and the adjustment
data
• A-scan
• single reading (position 1 of the measurement line)
• function list (including all current settings)
• Data Logger (if the version is available)
To do this, you need
• a printer with serial interface RS 232
• a printer cable (please see chapter 2)
Preparing the printer
The transfer parameter settings for the serial port are:
• Baud rate 0 (no transmission), 300, 600, 1200,
2400, 4800, 9600 (default), 19200,
38400, and 57600
• Word length 8 data bits (fixed)
• Parity none (fixed)
• Stop bits 2 (fixed)
In order to ensure a perfect communication, set the
printer to the parameters of the USM 35X.
Preparing the USM 35X
You decide on the type of printout by assigning the
key.
– If necessary, go to the third operating level.
– Select the function group CFG1.
– Select the function PRINTER, and then use the right-
hand rotary knob to select the correct printer driver.