GE Krautkramer USM 35X - Page 95

Krautkramer USM 35X Issue 01, 04/2005 5-47
Operation
Db Db Depth for gate B
Pa Pa Projection distance for gate A
Pb Pb Projection distance for gate B
Ra Ra Reduced projection distance for gate A
Rb Rb Reduced projection distance for gate B
Only for DGS:
ERS ER Equivalent reflector size
Gt dB Gt DGS test sensitivity
GrdB Gr DGS reference gain (= instrument gain
for the reference echo on 80 % screen
height)
Only for DGS and DAC:
Ha %crv Ca Echo height gate A in % referred to curve
Hb %crv Cb Echo height gate B in % referred to curve
DGS-Crv Dc Diameter of the DGS curve
class cl Flaw class according to JIS Z3060-2002
DAC dB db dB-value by which the DAC gain has
been changed related to the reference
gain (= instrument gain for the DAC
echo on 80 % screen height)
Configuring the USM 35X for a test application
General:
Alarm Al Choice of gates for alarm triggering:
gate A, B or A+B
H Note:
If you use the Data Logger option, values for the C gate
as well as a few special values for the Data Logger are
added to the existing ones, see chapter
Option Data
Logger .
– Select the function S-DISP.
– Use the right-hand rotary knob to select the required
value for the zoomed display.
H Note:
You can likewise configure all readings to be displayed
below the A-scan at the four corresponding positions.
Please refer to Configuring the measurement line .
Krautkramer USM 35X Issue 01, 04/2005 5-47
Operation
Db Db Depth for gate B
Pa Pa Projection distance for gate A
Pb Pb Projection distance for gate B
Ra Ra Reduced projection distance for gate A
Rb Rb Reduced projection distance for gate B
Only for DGS:
ERS ER Equivalent reflector size
Gt dB Gt DGS test sensitivity
GrdB Gr DGS reference gain (= instrument gain
for the reference echo on 80 % screen
height)
Only for DGS and DAC:
Ha %crv Ca Echo height gate A in % referred to curve
Hb %crv Cb Echo height gate B in % referred to curve
DGS-Crv Dc Diameter of the DGS curve
class cl Flaw class according to JIS Z3060-2002
DAC dB db dB-value by which the DAC gain has
been changed related to the reference
gain (= instrument gain for the DAC
echo on 80 % screen height)
Configuring the USM 35X for a test application
General:
Alarm Al Choice of gates for alarm triggering:
gate A, B or A+B
H Note:
If you use the Data Logger option, values for the C gate
as well as a few special values for the Data Logger are
added to the existing ones, see chapter
Option Data
Logger .
– Select the function S-DISP.
– Use the right-hand rotary knob to select the required
value for the zoomed display.
H Note:
You can likewise configure all readings to be displayed
below the A-scan at the four corresponding positions.
Please refer to Configuring the measurement line .