42 GE INFORMATION D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
CHAPTER 3: CONFIGURING THE D20E FIRMWARE
5. Click OK.
Result: The Network window appears as shown in Figure 8.
Figure 8: Network window
6. Select the Ethernet port you want to change by either:
– Double-clicking the respected Ethernet box, or
– Single-clicking the respected Ethernet box (highlighting the box) and clicking Edit.
Result: The Network - Configuration window appears.
7. Type in the new IP Address and Network Mask.
8. Ensure that Status > Active is set to On.
9. Click Finish.
10. Right-click a blank area of the screen.
Result: The Task bar appears at the bottom of the screen.
11. Click Sync in the Task bar.
Result: DAPserver Studio updates the D20E module with the new IP address and
restarts the device.
To Next Page
Loading...