GE PACSystems RX7i

Chapter 6. Service Request Function
GFK-2950C February 2018 315
Extended Format Output Parameter Block Format
Controller Fault Table Output Format
Address
I/O Fault Table Output Format
High Byte
Low Byte
High Byte
Low Byte
Unused
80h = Extended Controller
Fault Table
Address
Unused
81h = Extended
I/O Fault Table
Starting index of faults to be read
Address+1
Starting index of faults to be read
Number of faults to be read
Address+2
Number of faults to be read
Unused
Unused
Address+3—Address+14
Unused
Unused
Minutes
Seconds
Address+15—Address+17
(Time Since Last Clear,
in BCD Format)
Minutes
Seconds
Day of Month
Hour
Day of month
Hour
Year
Month
Year
Month
Number of faults since last clear
Address+18
Number of faults since last clear
Number of faults in queue
Address+19
Number of faults in queue
Number of faults read
Address+20
Number of faults read
Unused
Address+21—Address+36
Unused
Start of fault data
Address+37
Start of fault data
Address
I/O Fault Table Output Format
High Byte
Low Byte
Address
Unused
C1h = Extended
I/O Fault Table
with Remote Fault
Record
Address+1
Starting index of faults to be read
Address+2
Number of faults to be read
Address+3—Address+14
Unused
Unused
Address+15—Address+17
(Time Since Last Clear,
in BCD Format)
Minutes
Seconds
Day of month
Hour
Year
Month
Address+18
Number of faults since last clear
Address+19
Number of faults in queue
Address+20
Number of faults read
Address+21—Address+36
Unused
Address+37
Start of fault data