GE Voluson P8 BT16 - 3-13-2-2 Disconnecting from the WLAN; 3-13-2-3 Adding a WLAN Profile

GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 3 - Setup Instructions 3-77
6.) The Wireless Network Configuration tool with available Wireless Networks appear.
7.) Check box “Enable Wireless Connection”.
8.) Highlight the wireless network you want to use and then click Connect.
NOTE: If the WLAN fails to connect, review and/or recreate the Wireless connection in the Security tab.
3-13-2-2 Disconnecting from the WLAN
1.) Press the “Utilities” key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see Section Figure 3-76 on page 3-75
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
5.) Select the WLAN you are connected to and then click Disconnected.
3-13-2-3 Adding a WLAN Profile
1.) Press the “Utilities” key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see Section Figure 3-76 on page 3-75
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
Figure 3-78 Wireless Networks - Connect